Ryze Band Quick Start Guide

Ryze band with the main control button highlighted

1. Set The Current Time

1. Wake the screen

  • Tap the button once to show the time.

2. Enter Time Set mode

  • From the time screen, press & hold the button for ~3 seconds
  • The hour will start flashing.

3. Set the hour

  • Tap the button to increase the hour (each tap = +1).

4. Set the minutes

  • Press & hold ~3 seconds again to switch to minutes (minutes flash).
  • Tap to increase minutes.

5. Save & exit

  • Stop pressing buttons and wait ~8 seconds.
  • It will save and return to the normal time screen.

2. Set Alarm 1 (First Alarm)

1. Go to Alarm 1 screen

  • From the time screen, tap the button 5 times until you see Alarm 1.
  • If it shows "OF", that alarm is OFF.

2. Turn Alarm 1 ON + set time

  • Press & hold ~3 seconds to start setting Alarm 1.
  • The hour will flash.
  • Tap to adjust the hour.

3. Set minutes

  • Press & hold ~3 seconds to switch to minutes (minutes flash).
  • Tap to adjust minutes.

4. Save & Exit

Stop pressing buttons and wait ~8 seconds to save.

3. Set Alarm 2 (Second Alarm)

1. Go to Alarm 2 screen

  • From the time screen, tap the button 6 times until you see Alarm 2.
  • "OF" = OFF.

2. Turn Alarm 2 ON + set time

  • Press & hold ~3 seconds to set it.
  • Tap to set hour → hold ~3 seconds → tap to set minutes.
  • Wait ~8 seconds to save.

4. Turn an Alarm OFF (Alarm 1 or Alarm 2)

  • Go to the alarm screen (Alarm 1 = 5 taps, Alarm 2 = 6 taps)
  • Set it to "OF" (OFF)

5. Charging Your Ryze Band

Diagram showing the correct and incorrect way to insert the band into a USB port

Locate the built-in USB charging connector on the end of the band.

Plug the USB connector directly into a low-power USB source, such as:

  • A laptop USB port
  • A desktop computer USB port
  • A standard low-output USB hub (5V)

Insert the band straight and level into the port. (Refer to image above)

Allow the band to charge fully before first use.